Annnnnnnd we're back!

It's been a while since the last post, but over the past week a lot of progress has been made. 

Wired the following:
- starter signal switch
- PCM power switch
- fuel pump power switch

Put the switches in the blanks on the dash.



The rear half of the interior was put back into place after finding a place to put the PCM and deleted the back seats.


New front & rear sway bar bushings



Filled the bumperette holes in the bumper cover with sheets of carbon fiber I had lying around. 

The center section of the bumper cover has never been cleaned before, it has always been under the bumperettes and license plate. 






Almost ready to hit the road.



SUPER loud since its open headers until the exhaust can be fabricated. But it's roadworthy!!! Woo!!!




No comments:

Post a Comment